STEP 3. PLACING THE LONG BOLTS. The carrier is designed to load
the motorcycle from the left or right side using the ramp. There
are 3 sets of center holes and 1 set of upper holes on each
cradle. The large safety pins and clevis pins are used in the
upper holes. See FIG 5. The 4 long bolts are used in the
center hole to support the motorcycle tires. NOTE: Depending
on the size of your motorcycle, some bolts may not be
needed.
STEP 1. Place tire cradles inside support channel on receiver bar.
Attach with 8 short bolts, washers and nuts. There are 4 nuts,
bolts and washers per cradle. Note: The washer is placed onto
the bolt first and then inserted from the inside out. The nut
goes on the outside of the support channel.
STEP 2. Attach 2 bridge supports as shown and 2 ramp supports using
4 medium length bolts, washers and nuts. NOTE: When
mounting ramp supports, make sure flat surface is up and the
extra 3 inches is on the outside to support the ramp while
transporting.
ASSEMBLY INSTRUCTIONS
TIRE
CRADLE
SUPPORT CHANNEL
& 2” RECEIVER BAR
SMALL BOLTS
& NUTS
BRIDGE SUPPORTS
MEDIUM
BOLTS & NUTS
MEDIUM
BOLTS & NUTS
RAMP
SUPPORTS
LARGE
SAFETY
PINS
CLEVIS
PIN
RAMP STORAGE
BRACKET
STRAP HOOK
HOLES
STRAP HOOK HOLES (Not Shown)
RAMP
RAMP
MOUNT
IMPORTANT STEP: The front tire of the
motorcycle must rest down into the cradle and
be secured with a large safety pin and clevis pin.
This step is needed in case a strap is broken or
comes loose during transport. A second safety
pin is supplied. Depending on the size of your
motorcycle, this pin may not be needed. If this
pin is not used, secure the motorcycle tire with a strap. (not included)
MOUNTING AND LOADING MOTORCYCLES
STEP 1
STEP 2
The loading ramp can be
used on either side of
carrier. Make sure lip of
ramp is securely hooked
into ramp mount.
With feet firmly planted and
motorcycle in neutral, slowly
guide motorcycle up loading
ramp onto carrier. Use two
people if necessary.
Insert 2” receiver bar tube into the 2” receiver hitch and secure with a clevis pin.
(Clevis Pin not included) This carrier will only mount into a 2” receiver only.
3 4
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern